How to Choose a Gray Iron Casting Supplier

Choose a gray iron supplier on how well it controls the iron itself and how it proves the result against ASTM A48. Those checks are what gray iron adds to the supplier review you already run for any foundry.

Whether your part belongs on a green sand line or in no-bake molds is a separate question, covered in how to choose a casting process for cast iron.

Gray Iron as Its Main Metal

Look for a foundry that pours gray iron routinely in your class and in walls close to yours, because A48 leaves almost everything that makes the class to the foundry. Ask what share of the foundry’s gray iron runs in your class, and on parts with your kind of section.

Carbon Equivalent Control on Every Heat

A capable supplier calculates carbon equivalent (CE) on every heat and holds it to a target set for your class, since CE decides how gray iron solidifies and how much graphite it carries. The usual formula is:

CE = %C + (%Si + %P) / 3

On average, for unalloyed iron in a 1.2 in. test bar, Class 30 corresponds to a CE of roughly 4.2–4.3 and Class 40 to about 3.7–3.8. Treat those CE values as a guide to where the foundry should be aiming, never as a required range.

Ask for the CE of recent heats poured to your class and how the foundry handles a heat that misses its target. If you want chemistry reported with every shipment, write it into the order: A48 makes chemical composition a requirement only when buyer and foundry agree on it in writing.

Proof the Iron Meets the A48 Class

The supplier proves the class with a tension test on a separately cast test bar poured from the same lot as your castings, one test per lot. The class number certifies that bar, not the casting it represents.

Under A48, a lot is all the metal from one heat of a batch furnace. For a continuous melting furnace, a lot is the metal poured between changes in charge, processing or target chemistry, and no more than 4 hours unless the buyer agrees to extend it to 8. Ask how the foundry ties each bar to its heat and to the castings it covers, and check that the certificate shows the bar letter. If your castings are stress-relieved or otherwise heat-treated, the bars must go through the same cycle beside them.

Test Bar Size Matched to Your Section

Your order should name the test bar letter that matches the casting’s controlling wall; A48 lists that letter as part of the ordering information. Where no correlation between bar and casting has been established, the standard pairs wall thickness and bar as follows:

Controlling wall, in. [mm]Test bar
Under 0.25 [under 5]S
0.25 to 0.50 [5 to 14]A
0.51 to 1.00 [15 to 25]B
1.01 to 2 [26 to 50]C
Over 2 [over 50]S

The dimensions of an S bar are agreed between buyer and foundry.

Hardness Checks on the Casting

Ask for Brinell hardness at a named location on each casting, written into the order, because A48 carries no hardness requirement unless you add one. Name the location, typically a machined face at the controlling section, and the band agreed for it, so every casting in production is read at the same place.

Chill Control in Thin Walls

A supplier keeps thin walls from chilling by inoculating the iron just before pouring and by checking the melt with an ASTM A367 wedge or chill test before it pours thin-walled work. A367 adapts its wedge test to the higher-strength gray irons and its chill test, cast against a metal or graphite plate, to the softer grades.

Ask how often the foundry breaks a wedge and reads the chill depth on the fracture, and what result sends a melt back for more inoculation. If machined areas must be free of chill, write that into the order as a special requirement, since A48 has no chill clause of its own.